Shearing machine is widely used in machining a cutting equipment, it can cut a variety of thickness of steel materials. Commonly used shears into flat shear, rolling shear and vibration shear 3 types. One of the most widely used machine. Shearing thickness of less than 10mm shearing machine for mechanical transmission, more than 10mm for hydraulic transmission. General use of foot or button manipulation for single or continuous cutting metal. When operating the shears, roll forming machine suppliers tell you that you should pay attention to:
(1) Before work carefully to check the shearing machine ministries are normal, the electrical equipment is intact, the lubrication system is clear; remove the table and placed around the tools, measuring tools and other debris and edge scrap.
(2) Do not operate the shears only by one person alone. Coordinate feeding by 2-3 persons, control the dimensional accuracy and material take-in etc., and determine the unified command by one person.
(3) According to the provisions of the thickness of the shears, adjust the shears gap shears. Not allowed to cut 2 different specifications at the same time, different materials of sheet metal; Shear sheets require a smooth surface, not allowed to shear the narrow sheet can not be pressed.
(4) Shears belts, flywheels, gears and shafts and other moving parts must be installed protective cover.
(5) The shears fed by the shears operator should be kept at a distance of at least 200 mm from the scissor opening and out of the hold-down device.
The protective fence placed on the trigger can not block the operator's eyes and can not see the cropped area. Waste generated after operations have angular, the operator should be promptly removed to prevent being stabbed, cut.
