Analysis of the Use Function and Matters Needing Attention of Air Duct Sealing Machine

Ⅰ. Introduction to the use and functions of the air duct seaming machine

The working range of the air duct seaming machine is 800mm to 1250mm, and the baffle can be adjusted with an Allen wrench when in use. Before stitching, insert the right-angle edge into the joint opening gap, and manually flatten the two ends of the rectangular air duct by 50mm. Adjusting the baffle method: the baffle is divided into 2 lengths, 4 pieces of 100mm and 1 piece of 50mm. The length of the baffle should not be less than 50mm than the length of the air duct.

1. Description of the air duct seaming machine mechanism: There is a bolt adjustment mechanism on the left plate of the air duct seaming machine. This mechanism is used to adjust the working length of the air cylinder and adjust the specific length of the seam.

2. Description of the length adjustment mechanism of the air duct seaming machine: Loosen the 4 bolts with the hexagonal wrench, shake the handwheel to adjust the length to the required length, and then tighten the 4 bolts. The tube is pushed into the work area, the foot switch is stepped on, and the seam is completed.

Ⅱ. Notes on the use of air duct seaming machine

The air duct seaming machine is a frequently used equipment in the machinery industry, but you often find problems after using it for a period of time. Today we will introduce you to the matters needing attention when using the air duct seaming machine.

Item 1: Air leaks in some places in the use of the air duct seaming machine, air leaks at the air inlet, need to replace the joint or speed control rod, air leaks, switch valve leaks, need to replace the O-ring, air leaks at the exhaust port, It is necessary to replace the O-ring or remove the on-off valve debris.

Item 2: The air duct seaming machine sometimes stops working after working for a few times. This is usually because dirt has entered the cavity. It needs to be disassembled to remove the dirt, and it can be used normally after reinstallation.

Item 3: The hammer head is easy to fall off during the operation of the air duct seaming machine. This is usually caused by accidental air strike during operation, resulting in damage to the spring or the wrong fixed position of the spring and the hammer head. This needs to be replaced or reinstalled.

We get the reputation and value from our clients for improvement proposals to meet the demands of the world's advanced technology. And our products are exported to more than 120 countries including Poland, Switzerland, Turkey, Russia, the United States, Canada, Mexico, Venezuela, Chile, Saudi Arabia, the United Arab Emirates, Syria, Australia, Singapore, India, Malaysia, etc.

COMIFO offers unparalleled after sales service and attention. In addition to the one-month warranty, we encourage and provide operator training. Welcome customers from all over the world to visit and consult.