Production Process and Processing Procedures of Three Line Common Plate Flange Machine for Air Duct

The production line of the air duct production and processing is the third line of the air duct production line, and the common plate flange machine is the equipment used for flange forming, which is indispensable. If you do not know enough, then the use can not achieve the desired result. Let's learn more about the relevant knowledge of the three-line common plate flange machine for air duct production.

Ⅰ. The production steps of the common plate flange machine

1. It is necessary to press into a piece of flange, and then shape it after blanking. Finally, the four corners are stamped and installed.

2. The flange is connected by a flange card. Cut into uniform size for installation.

3. The common plate flange machine is easy to operate, which improves work efficiency. The size is also prepared and the quality is high.

4. The common plate flange machine can be used in a variety of production equipment: shearing machine, lock forming machine and so on.

Ⅱ. How to maintain the three-line common plate flange machine for duct production?

If we want to extend the service life of the three-line common plate flange machine for the air duct production line, we must pay attention to the maintenance of it.

1. Usually we should place the common plate flange machine in a dry place. The three-line common plate flange machine for air duct production should not be damp, and other impurities should not enter the machine, and otherwise, they will make the machine easy to damage.

2. We need to add some lubricating oil to the common plate flange machine on a regular basis, so that the common plate flange machine can operate more efficiently. After a period of time, we must check whether the machine nut is loose to ensure safe use and also clean up regularly.

The production cost of the three-line common plate flange machine for air duct production is relatively low, and the sealing performance is good, and the installation is simple. It is an ideal equipment.

Ⅲ. Machining procedure of the three-line common plate flange of the air duct production line

1. Process semi-finished products: number them according to the drawings designed by the customer, then cut them, corresponding numbers, assemble, inspect, and ship.

2. Finished product processing: measure the size and number according to the customer's construction drawing, then process it, and then ship it after acceptance.